Why am I getting an error while reading/writing the SD card for my legacy DataMaster™ device?

Follow

If you're getting an error while reading your SD card when taking a sensor reading, take these steps:

  1. Ensure the SD Card is not “write protected”
  2. A sensor data-file may have been removed. Try to delete the sensor from the job and then start over by taking a new reading.
  3. Try deleting the job and then creating a new job or adding the sensor to a different job when the sensor is once again read.
  4. Try using a different SD Card.

Note: Deleting a sensor and/or job will result in data loss that exists on the SD Card. It is always good to backup your SD card periodically, such as after returning from a job site. 

Please visit http://bit.ly/1d7dwVh for more information or call 1.800.634.9961 to talk to a professional.

Have more questions? Submit a request

Comments

Powered by Zendesk